Results 1 to 10 of 11
Thread: Extruder for a 4880?
Threaded View
-
12-12-2016, 01:45 AM #10
- Join Date
- Dec 2015
- Location
- Seattle
- Posts
- 38
I realize we don't have the same model, but it seems to be similar issues. Had a problem with the motor wires breaking, perhaps its that? I have a dual extruder and changed the wires from the second extruder, both at the motor and on the board to figure that out. Mine also appears to be a heat issue, although it reads the heat just fine. I haven't been able to figure out if it's a thermistor or if it's the heating element directly (have the latter on the way) but I'll find out by the end of next week.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion