Results 1 to 7 of 7
Threaded View
-
12-10-2016, 01:29 PM #3
- Join Date
- Apr 2016
- Posts
- 120
I've had this where the extruder stopped heating for a few minutes, causing a gap, then spaghetti!
In my case, it was a board fault, with a dry joint to the heater socket. Never had this issue again since.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)