Results 121 to 125 of 125
Thread: Wanhao Duplicator I3 3D Printer
-
12-09-2016, 06:22 PM #121
- Join Date
- Dec 2016
- Location
- Jacksonville, FL
- Posts
- 2
Hello folks. Hope I can get some newbie assistance here.
I just bought a Monoprice Maker Select V2 which, I am told, is a rebranded version of the Wanhow Duplicator. My problem is trying to set up Cura.
What settings do i use? I attempted to do a "Custom" printer setup and waded through all the (thousands???) of settings but in the end, Cura does not recognize the printer is even plugged into the USB port. I can print from the micro card and the test parts included with the printer pre-installed on the card print OK, but I would really like to print from Cura if possible.
Any help would be appreciated.
Tom
-
12-09-2016, 06:53 PM #122
- Join Date
- May 2016
- Location
- SE Wisconsin
- Posts
- 206
I refuse to use my computer to run a print. If the computer updates or shuts down mid-print it's boned.
Just my two cents.
-
12-09-2016, 08:28 PM #123
- Join Date
- Dec 2016
- Location
- Jacksonville, FL
- Posts
- 2
Fine, printing from the card is not too terrible.... but Cura setup is kicking my ass. Any assistance there would be appreciated.
Tom
-
12-09-2016, 08:32 PM #124
- Join Date
- May 2016
- Location
- SE Wisconsin
- Posts
- 206
That would depend on what your specific symptoms are.
I started out with a default profile, which printed ok, and then tweaked one setting at a time to learn how it affects my material.
-
08-27-2017, 04:52 PM #125
Does anybody happen to have the firmware defaults for Marlin firmware for the Duplicator i3 Plus? I am actually looking for optimized versions of the settings beyond Page 25 of the manual.2017-08-26 08_05_35-Octopi [OctoPrint].jpg
2017-08-26 08_05_10-Octopi [OctoPrint].jpg
Design not printing solid
09-17-2024, 06:12 AM in 3D Modeling, Design, Scanners