Results 1 to 10 of 11
Thread: Filament Dryer
Threaded View
-
12-05-2016, 02:14 PM #6
- Join Date
- Aug 2015
- Posts
- 256
I do the same... I installed a waterproof storage box above my printer and and route the filament guide tubes into the bottom of the box. Within the box I have a paper lunch bag of drierite dessicant.
I have a humidity meter, and outside of the box it is usually 40-50% inside the box it's about 3%. Once it goes over 10% I recharge the dessicant.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion