Results 1 to 3 of 3
-
12-03-2016, 02:36 PM #1
- Join Date
- Dec 2016
- Posts
- 6
Adhesion issues, snowflake on mp mini
I'm trying to print Thingiverse 195468 snowflake.
The skirt looks good but the first layers are spotty, some adhere, some don't, and it don't see any obvious cause.
IMG_0566.jpg
Using cura
layer height .1
wall and top thickness .8
infill 100Last edited by thewaka; 12-03-2016 at 03:20 PM.
-
12-03-2016, 03:18 PM #2
- Join Date
- Dec 2016
- Posts
- 6
Update, I decided to make a 100x100x2 test print, so far it works fine.
https://imgur.com/gallery/KgB4OLast edited by thewaka; 12-03-2016 at 03:27 PM. Reason: Added pic
-
12-03-2016, 04:08 PM #3
- Join Date
- Dec 2016
- Posts
- 6
Update: see pic.
IMG_0178.jpg
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion