Results 1 to 10 of 10
Thread: Clicking started after cleaning.
Threaded View
-
11-29-2016, 10:18 PM #8
- Join Date
- Dec 2015
- Location
- Seattle
- Posts
- 38
A bit delayed, but I appreciate your response. I've failed to get it working thus far. The motor runs fine, the PTFE tubing has been replaced, the metal parts of the hot end have been swapped/cleaned and replaced multiple times. Even the gear/guide/housing have been swapped from right to left and so on.
I'm thinking it's something to do with the extruder setup, which is what I believe you're referring to with the screws?
EDIT: I just ordered an all metal bowden setup. I think it should fix the issue. I hope so.Last edited by TiredJuan; 11-29-2016 at 10:27 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion