Bed Temp not accurate

[uncle_bob]

I know it is frustrating... But it really is helpful to turn on your bed and nozzle and let them stabilize for 5 or 10 minutes prior to starting a print. When I decide I want to print... I want to print. But if it is something I care about, waiting 5 or 10 minutes really helps!!!!

Hi

With a probe (any mechanical probe) you probably need the bed and carriage in a defined location as the warmup occurs. Where that is probably does not matter as much as it being the same every time. Most probes heat up more from the bed than from the extruder and that's why the bed to carriage relation matters.

Bob