Results 3,721 to 3,730 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
11-13-2016, 09:57 AM #3721
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
It is showing me the temp isn't good. Also to see my single wall width. I went up in temp and the sides got worse. Trying a lower now. Anyway I am just trying to get a feel for the material.
Jump in and let me know what you think on the temp, extrusion and speed settings to test with.
Last edited by wirlybird; 11-13-2016 at 10:06 AM.
-
11-13-2016, 02:05 PM #3722
Sounds like you need to increase multiplier. There is no way to get a .4 wall with a .4 nozzle. That isn't what extrusion width means. A .4mm round filament under pressure is gonna come out of that hole bigger than .4 due to die swell. Then it gets smashed into a 200 micron height and that increases the width also.
-
11-13-2016, 08:26 PM #3723
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-13-2016, 08:36 PM #3724
Kinda hard to tell in a picture. Everything always looks worse in close up pictures than it really is. Are retractions randomized? If yes, don't do that. Possibly too much retraction, but without seeing every setting used it is hard to tell.
And I hate photobucket, what an ad ridden site that has become. No I don't want to buy a camera. lol
-
11-14-2016, 10:53 AM #3725
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Anyone tried to update the firmware on your QIDI? Isn't it a non standard sailfish?
-
11-15-2016, 02:25 PM #3726
-
11-15-2016, 03:06 PM #3727
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
11-15-2016, 06:33 PM #3728
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
newegg.com has good prices on Hatchbox. Free shipping. Not as fast as Amazon but Amazon wanted 45 for the color I wanted and NE was 22. Paid 22 last time from Amazon.
-
11-16-2016, 01:10 PM #3729
- Join Date
- Nov 2016
- Posts
- 1
lots of good info on here thanks! my prints seem to be doing ok but at times my printer sounds like it is going to break itself while filling in. the head moves so much it shakes everything. is the acceleration too high from factory? how do i change it ?
thanks
-
11-16-2016, 01:49 PM #3730
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Angus (aka Maker's Muse) has done a review of the QiDi Tech X-One 3D printer. Apparently QiDi sent him one to check out.
Spoiler Alert: His review is quite favorable, aside from the color...
You can watch his review at https://youtu.be/B-rIc3XIYUg
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help