Results 1 to 10 of 12
Thread: Control board upgrade?
Threaded View
-
11-09-2016, 02:45 PM #12
- Join Date
- Nov 2016
- Posts
- 7
I gathered that from your forum. For a job I am working on I require varying layer heights in one print, and also varying widths in the same print. A controller that can fill that requirement is an upgrade, but I did not come to this board to debate the the name "upgrade", just to see if someone had done it yet.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion