Thanks for the tips. I may try the PETG this weekend if I get time. Been focused on the new printer.


Quote Originally Posted by Talon 3D View Post
With the PeTG it was a bit tricky.
Bed 90 (PrinteBite) Bed 100 (blue sticker) nozzle 230, I've also slowed down to 24 on the print speed. No fan with panels on.

PLA dual printing bed temp 80 to 90 depending on the form, large areas needed hotter. Nozzle I kept at 210 to help blend the two filaments. Speed was 32 can go faster but for the really fine detail I kept it slow.
I made this fan duct in ABS though for printing PLA/PHA, first two layers no fan then 90%the rest of the time. Front door open but top on for the PLA/PHA but normal PLA for open, top off and side panel open.
http://www.thingiverse.com/make:256240

I hope it helps.