Results 1 to 2 of 2
Thread: Z offset issue
-
11-07-2016, 10:44 PM #1
- Join Date
- Oct 2014
- Posts
- 134
Z offset issue
RESOLVED - I reloaded the firmware and it's back to normal now.
I changed the RAMPS board on my printer.
Z offset was set at 1.25 previously. After changing the RAMPS board, now it's decided that it wants the Z offset to be .25
The motion menu on the LCD will not allow me to go below .50
Two questions -
1) HOW did changing the RAMPS board affect the Z offset?
2) Why can't I set the Z offset lower than .50 in the motion menu?Last edited by kd7eir; 11-07-2016 at 11:31 PM.
-
11-10-2016, 05:34 PM #2
- Join Date
- Jul 2016
- Location
- Pennsylvania, USA
- Posts
- 255
There are config settings in Marlin for the resolution of the Z offset setting process.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help