Originally Posted by
DrMacZed
Well, after a lot of cursing and head scratching, I figured it out. I had the E-steps on the extruder set way, way too high. They were over 800 I cranked them down 100 steps at a time until I got something that looked like 100 mm of filament or so then did a calibration test and ill be damned if I was only one step off from as close to perfect as I can get. No more skipping. No more piles of ground up filament in the extruder.
Thanks for all the advice.
Scott
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help