Results 1 to 10 of 139
Thread: Open Sourcing the Pegasus
Threaded View
-
10-19-2016, 04:06 PM #11
- Join Date
- Jan 2016
- Posts
- 121
Hi Luca,
I tried getting in touch with you on the FB group you created then deleted, and also the OpenSLA community... but without being an "expert" at Linux and development, I would not recommend trying to use my firmware at this time. You can backup the old one. The best way to do this is to buy a second beaglebone black and install my firmware on the new BBB and leave the old one untouched.
Theoretically once I get the software worked out it should be the ability to use any resin. You would need to use a 3rd party slicing tool (I use slic3r right now and will provide the general settings I utilize).
When and if I think my firmware is ready for more prime time beyond just anyone with the capability to test it out and help development, I might be willing to offer BBB's with the firmware pre-installed in which case all you need to do is swap the BBB's and you would be up and running.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help