Results 1 to 10 of 35
Thread: Banding/Wobble/Layer Shift
Hybrid View
-
10-18-2016, 05:36 AM #1
could anything else be adding extra vibration ?
noisy cooling fan for example ?
Also clean ALL the rods. Not just the z-screw itself but the guide rods as well.
basically when I do a clean (one is due) I wipe down every guide rod and the screw.
You can actually hear the difference in the sound the printer makes afterwards.
Your settings look fine, what make is the pla ? And is this the same roll that worked fine before the problem started ?
-
10-18-2016, 09:55 AM #2
- Join Date
- Aug 2016
- Posts
- 29
Not that I know of. There is an extra cooling fan I have but It was there and on before this started giving me issues so I doubt its that.
Yes I cleaned and oiled all the rods.
Speaking with the manufacturer hes telling me to check the bed screws and the screws holding the z motor. Checked all screws and all were tight, although I was able to tighten the zmotor screws a couple more turns.
Told him that and hes saying he thinks its still a loose screw somewhere. Idk what else to check.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion