Quote Originally Posted by wirlybird View Post
You are missing the point. That applies to Marlin machines that use straight G-Code. Sailfish does not store steps settings in the firmware. With X3G-consuming printers, the steps per mm is done during the X3G generation, and all the movements in the X3G are expressed in terms of steps rather than mm.

Check this out. http://3dprintboard.com/showthread.p...nter-READ-THIS
Ok, so sailfish does not store those things in the firmware...but it does use gcode correct?
Then why is giving cgode commands directly to the machine only an option with marlin?

If the only adjustment I have for over/under extrusion is the multiplier in the slicer then I am screwed. Up to 1.25 now and still only about 75-80% of first layer is there....lots of gaps.

At least it it not so humid today...not needing 1/8th inch thick coat of glue to get things to stick lol.