Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
10-16-2016, 12:31 PM #10
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
You are missing the point. That applies to Marlin machines that use straight G-Code. Sailfish does not store steps settings in the firmware. With X3G-consuming printers, the steps per mm is done during the X3G generation, and all the movements in the X3G are expressed in terms of steps rather than mm.
Check this out. http://3dprintboard.com/showthread.p...nter-READ-THIS
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion