Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
10-06-2016, 10:58 PM #11
I have still never hit this issue with any type of filament but I was aware of the stock setup being able to jam the roll with the spool holder and I stopped using it a long time ago. In my drybox setup I've only had it unwind oddly off the spool to where it almost wraps fully around the spool next to it. It will still continue to print even when unwinding oddly but I can see more pressure is being applied to the feed line.
Are you using the stock filament holder on the rear of the printer?
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion