Results 1 to 10 of 396
Threaded View
-
09-23-2016, 10:22 AM #11
- Join Date
- Feb 2015
- Posts
- 371
I am getting some inconsistent results. I have had about 50% fail rate since updating to the new firmware.
I think I have tracked my problem down to the ABL probe. It seems to over extend which results in a crash. I readjusted the extend and retract angles. I tested these by running a g28 and then a g29 and it worked. I shut down the printer.
The next day I ran a print and it failed. Looks like the ABL probe is using the old values even though the firmware has been updated with new values.
Ideas on where to start?
New Here, don't print but need a...
06-20-2024, 12:18 PM in General 3D Printing Discussion