The 10mm rods and bearings i get come from Misumi so generally better quality. How much? i don't know.... The bearings I specced also have a 4 hole flange, but I am pretty sure a 2 hole flange will bolt up. The top and bottom brackets help along with the stiff platform.
Why did you spin the bed? Is it a different heat platform etc? How much for the whole kit? I am guessing I could save or use my 10mm stuff as needed.
My flange is 4 hole where the bearing are on the smooth rods as is the "bearing" for the screw z rod.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help