Results 1 to 9 of 9
Thread: Shifted / Offset layers in print
Threaded View
-
08-01-2016, 05:31 AM #1
Shifted / Offset layers in print
Hi everyone,
I am printing in flexPLA and at some points the 3D printer creates shifts in the layers, only in the X-direction.
See the pic attached for an example.
There can be many causes:
http://reprap.org/wiki/Shifted_layers
The belt tensions are exactly right and the motors work fine.
I suspect a backlash in one of the C-clamps causing at some point too much friction.
Or can it be something simple like the arms needing oil?
Has anyone else had the same problem?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion