Results 1 to 10 of 48
Threaded View
-
07-27-2016, 05:12 AM #1
- Join Date
- Jun 2015
- Location
- Sydney Australia
- Posts
- 36
Auto-leveling using an Inductive Sensor
Just wondering if anyone has or tried to implement Auto-leveling (tramming) using an Inductive Sensor with FF Creator series. From what I have read so far you will need:
- Sailfish 7.7/4.7 Release (this firmware supports Auto-leveling)
- Control board with ATmega 2560 processor
Here is a link http://www.instructables.com/id/Enab...ter-Marlin-Fi/ which gives you a good idea, but please note the link is based on Marlin Firmware.
I would be very interested to hear from anyone of their experiences.
Thank you
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion