Results 1 to 10 of 17
Thread: gcode for quieter printing
Threaded View
-
07-24-2016, 08:42 AM #1
gcode for quieter printing
Hi all!
A while back I ran across some gcode on another forum that adjusted the torque used for the stepper motors during printing. The result was it made the printing a tad quieter. I've lost that gcode. Would anyone here know what the code was or know where the original post was that talked about making the stepper motors a bit more quiet? I just recall it was a single line put into the pre-printing setup of the gcode. I've found stuff on adjusting voltage to achieve this, but I recall at least that it wasn't voltage in this case, more like it was torque settings or similar. It might also be something about "vrefs" but I don't know the code to change those.
Thanks!Last edited by Nargg; 07-24-2016 at 08:54 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion