Results 1 to 10 of 12
Thread: ABL Home Position Question
Threaded View
-
07-19-2016, 03:38 PM #1
ABL Home Position Question
Hey everyone! After almost a year of having the parts to do so, I've finally followed the ZennmasterM ABL tutorials and have ABL "working"!
For some reason, I can't figure out why my G28 home axes command is putting my hot end in the center front of my bed. Previously, I had my home position set to the rear left corner of the bed out of the way of the print. My concern is that a print will finish and when the printer homes at the end, it will smash into the center of the print.
Has anyone had this problem? Thanks in advance!
gmay3
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery