Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
07-15-2016, 10:38 PM #11
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Ideally, the tubing should be PTFE. Teflon is slippery and will have much lower friction with the filament. I use 4mm ID, 6mm OD style. I did not get the 4mm OD, 2mm ID stuff, seemed to me it would just be more likely to bind with the filament.
If you have a setup that can support the single long hoses, that should work fine.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help