Results 1 to 8 of 8
Thread: ABS Gets Stuck Half Way Through
Threaded View
-
06-21-2016, 06:46 PM #1
- Join Date
- Aug 2014
- Posts
- 8
ABS Gets Stuck Half Way Through
Hi not long had my ctc brought is as my clone makerbot board stopped working
so brought a ctc basically the same upgraded the feeder and replaced the throats to ones that don't use ptfe tubes. (Same setup I was running before)
but now have the problem when it seems to jam when it starts the infill. (same file iv been using time and time again with no problem) I am using sailfish 7.7 abs temp is 240-250 and bed temp is 110c . when it blocks if I pill the filament out and reload it no problems will reload and print again until infill.
I have tried the olive oil trick on the tip of the filament when loading and this makes it print ok??? (not even sure its safe to do with abs I read its more for pla) I don't want to relies on oiling it all the time though? what could be the problem?
many thanks any help will be grateful!!
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help