Results 1 to 4 of 4
Thread: Capacitive sensor issue?
Threaded View
-
05-28-2016, 03:54 PM #4
- Join Date
- Apr 2016
- Posts
- 30
I think I got it. The enstop was wired according to every picture Ive ever seen for the RAMPS board. Blue/Black/Blank. I hard wired the blue to ground and, have the black, sense wire to the first pin on the Z-MIN. Now all thats left is to get the firmware to understand there is no ZMAX and adjust the offset.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion