Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 4110

Threaded View

  1. 04-26-2016, 05:34 PM #11
    DarkAlchemist
    DarkAlchemist is offline
    Engineer
    Join Date
    Aug 2014
    Posts
    627
    Quote Originally Posted by KludgeGuru View Post
    They are not the best solution but many people have had good success with them so I believe your statement of "you might as well not even try them" is in error.
    For me I wouldn't as I run 110c-115c bed temps all of the time. Now if someone is only doing PLA/PET and prints these in ABS then rock on.

    edit: Last few minutes and someone outbid me. Doesn't matter Emily told me what they would accept as a minimum so I just made an offer with that minimum and a note letting them know what Emily said to me.
    Last edited by DarkAlchemist; 04-26-2016 at 06:02 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules