Results 1 to 10 of 125
Thread: 10" Pegasus Build
Threaded View
-
04-13-2016, 12:54 PM #19
Yeah, a lot of people have said the MakerFarm spool holder has been at least a major contributor. I didn't mention having issues with it because I never used it, or didn't use it longer than I had to.
FYI - someone suggested one of the unused wood parts shown in post #93 is an alternate spool mount, but it still relies on the poor design of having the spool bounce along over a fixed wood edge. Not sure where you'd mount that on a Pegasus without losing a lot of print volume. Perhaps on the rear side somehow. FOLLOWUP COMMENT: That alternate spool mount is used on the 12-inch Pegasus that utilizes a box frame around the printer.
Moderator RobH2 used to jump in and discourage people from mounting a spool high up on a printer, arguing that any momentum it picks up as the printer frame vibrates or wobbles can exasperate print quality issues. Just sharing what others have said before.Last edited by printbus; 04-26-2016 at 11:22 PM. Reason: 12-inch Pegasus clarification
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion