Results 1 to 10 of 39
Thread: Auto leveling
Threaded View
-
03-04-2014, 04:04 PM #1
Auto leveling
Hey guys,
Just wanted to make a small blog of this topic,
I am going to order a servo and new micro switch, And i should try in the near future depending on the shop delivering it on time to get my printer up with auto bed leveling,
I first didnt know if i should do this as i have a fan duct that uses all that space wich i would need to remove to get this auto bed leveling in place,
But i guess it will be worth it, hopefuly,
Might also buy a new hotend after this wich probably would be a E3D hotend as its been proven to do reasonable prints,
Tryed other hotends but they just didnt fit the printer, and the E3D will.
Anyhow,
Best regards,
DrLuigi
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion