Results 1 to 5 of 5
Thread: CTC thermocouple
Threaded View
-
03-16-2016, 10:38 AM #2
You will need another accurate digital thermometer with thermocouple-probe
to get an accurate temp of bed.
The bed-temp circuit on Mobo will not read accurately below about 50C
Using digital-meter, I found that temp on top of glass-plate is about 12.C lower than at the metal-plate below it, also.
So if using a glass-plate on bed, like you should, then adjust temp up to compensate for that difference.
I found that setting of 85.C, for bed, is good for PLA filament,
which is about 73.C on top of glass.
(center of bed gets a little hotter than outer edges)Last edited by EagleSeven; 03-16-2016 at 10:53 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion