Results 1 to 3 of 3
Threaded View
-
03-06-2016, 01:49 AM #1
- Join Date
- Mar 2016
- Posts
- 2
Updating the board with a Atmega2560
Hi,
I got an old mightyboard that was a bit broken, repaired it and replaced the Atmega1280 cpu with a larger Atmega2560 as some sailfish features are suposedly only available for this one.
Now i did not found any instruction how to firmware on properly.
I got a boot loader installed and I can upload Atmega2560firmwares form replicator G but non is specifyed to be the right one for the CTC printer.
So which one should I take? Also what stuff do I need to put into the EEPROM, as its a new chip its obviously empty.
Any advice would be greatly appreciated.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help