Hi guys,

I'm struggling with levelling a FF Creator Pro bed and I would like your expertise on this matter. Here's what I did:

1. At first i've done a levelling operation that they recommended, the one with their blue card and it all went good for a while. However after trying to print some large objects with ABS (noticed that PLA isn't that picky) first layers had issues sticking to the bed (btw I'm using a BuildTak surface mat).
2. The next thing was to try and level the bed with a dial indicator and that's when I realised that even though I would end up with having the same readings on the corners as the carriage passes the center area it seems to be closer that the edges and that breaks the level procedure altogether. I've read on the forum that this might be caused by the fact that the carriage is stressing the X-axis and it's sagging a little. However, what's your recommendation in this case, is there a workaround for this issue?

Thanks in advance!