Nope that 2 cents is helpful thank you!!! No idea in the makerbot where id set the extrusion speed or how to even figure out what it should be for my printer but I will find it. I am going to probably start with Slicr and see how that works for me. I will connect my active cooling fan as well but dink with the temperatures... I did get that feeler guage to measure out .13mm and hoping thats not too close for the next layer of extruding. I didn't recall the printer doing this when I first got it, perhaps its the secondary issue of the extruder speed I might of fat fingered that value (Saying I actually found it in the software at one point and must of changed it for some reason). I will try this stuff...I got alcohol to clean my print bed (of all the glue stickiness I hope too). Then I was going to try painters tape as I got a roll of that. I was wondering with the aqua-net what do you have to do between prints?