Results 1 to 10 of 139
Thread: Open Sourcing the Pegasus
Threaded View
-
02-17-2016, 11:58 AM #11
- Join Date
- Jan 2016
- Posts
- 121
I'll have to take a look at what they have. I'm currently using slic3r with some Muve3d laser settings for my config file to generate g-code (what the printer uses to move the laser point/etc). I don't know if it'll do reliable prints with the FSL. I'm mainly worried I will burn through vats faster than I can keep up while debugging.
I stopped using my printer because my workspace was in my garage, which is heated, but would cost a fortune to heat to 70 degrees so it stays around 40-45 in the winter and my prints went from ok to dead over night when the temps dropped in 2014.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion