Results 1 to 2 of 2
Thread: First Layer issue -3D printing
Threaded View
-
02-15-2016, 11:08 PM #1
- Join Date
- Jan 2016
- Posts
- 10
First Layer issue -3D printing
Hi guys,
I got a first layer issue during printing PLA. I have tried several times but still have same problems. At the beginning the print was quite nice, but after a while, these is are "bumps" on the surface. Some people said it is about the distance between nozzle and the bed. I have done some adjustments on the distance but problem still exists.
I'm using the Flashforge Finder, which has a pre-cut blue tape on the build plate and has no heated bed.
It would be grateful if someone can help me to solve this problem. Thanks a lot.
IMAG1094.jpgIMAG1093.jpg
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help