Results 1 to 3 of 3
Thread: Some parts printing small
Threaded View
-
02-02-2016, 12:07 PM #1
- Join Date
- Jan 2016
- Posts
- 3
Some parts printing small
Hi All,
I have a Monoprice Architect (FF Creator) and some, not all, of my parts are printing smaller than the model. I create a .5" cube in Fusion 360, slice it in either Replicator or Cura it prints within a few thousandths of .5".
If I create the model below, It prints too small in X and Y. Z is OK. My inner circle should be .33" and it's printing at .294". The next circle should be .81" and I'm getting .75". The outer edge should be 1.125" and I'm getting 1.070". Do I have a model problem? A slicer problem? Is it shrinking that much? Something else?
thanks,
Steve
Screen Shot 2016-02-02 at 10.04.20 AM.jpg
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion