Results 1 to 10 of 22
Thread: FET Bed Heater Board
Threaded View
-
02-01-2016, 03:51 PM #7
On the relay board, I recall maybe a couple of other threads where, in addition to providing a MOSFET switch, the person was adding other useful stuff onto their custom board. For example, adding an ABL servo or a Raspberry Pi Octoprint controller can leave you starved for 5V, so people were adding 5V regulators on their boards. I remember suggesting that providing 12V distribution and a few lightweight MOSFETs for things like fans or lights would be a good idea.
Last edited by printbus; 09-20-2016 at 11:37 AM. Reason: image and attachment issues have improved
Resin has changed after...
06-18-2024, 10:34 AM in General 3D Printing Discussion