Results 1 to 10 of 10
Threaded View
-
01-31-2016, 06:59 PM #8
Hey.
Just like to say I signed up for the sample program.
The sheets CS Hyde sent out worked great for me, and I just published a video with a full review of my findings.
The video is here. https://www.youtube.com/watch?v=JJd0_lcbiMA
As far as your questions, Mjolinor, my setup is about the same as yours, using polycarbonate on a non-heated bed. No sweat at all getting it to flex enough to pop things off the bed. Truly a great product that needs more attention.
Application was good at first, but better the second time around using windex and a credit card for a squeegee.
Parts stick nicely under normal scenarios with PLA and PLA-PHA, and pop off very easily after you're done.
Thanks guys!
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion