Results 1 to 10 of 16
Threaded View
-
01-21-2016, 03:31 PM #1
- Join Date
- Jan 2016
- Location
- WI
- Posts
- 10
Random crap prints out of nowhere!! DaVinci 1.0 (Repetier 0.92Mod) / Rep Hst v1.6.0
First off, Im a noob, Ive been printing for about 2-3 months roughly.. I ordered an XYZprinting DaVinci 1.0 printer and soon discovered that the factory firmware/interface was crap, so I flashed Repetier 0.92Mod onto my machine (and Repetier Host v1.6.0 on my PC). Ive been printing ABS ever since with little to no issues, until last weekend..
I print alot of personal vaporizer prototype pieces for myself and friends. I have previously printed these pieces multiple times with success, now, same file, same settings, im having a weird issue.. doesnt matter what filament brand I use..
- I double checked Calibration and found that only my steps per MM were off for my Extruder. (Fixed that, still no difference)
- I have tried almost every combination of speed/Ext temp imagineable.
- I have Leveled the HPB over and over.
The pieces pictured below were printed at:
Layer Height: .2mm
First layer height: .3mm
Infill: 13% rectilinear
No support or raft (only bare kapton tape)
Speed: 40mm/s (first layer 25%)
EXT Temp: 225c (230c for first layer)
Bed Temp: 100c (110c for first layer)
Running out of ideas here... So any constructive input is welcomed!
Last note: These pieces were printed upside down so the "taper" is an overhang rather than facing up.
I dont even know how to explain this issue.
12592000_10153901190733188_1463144582_o.jpg12562648_10153901190613188_2103117787_o.jpg
Thank you for your time!
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion