Results 1 to 10 of 48
Thread: Nightmare start
Threaded View
-
01-21-2016, 07:34 AM #6
No, just a Dry cloth should get it off , when it starts to melt.
A little on outside of nozzles does not hurt anything, as long as it's not dripping off
I'm pretty sure the main problem was that the Layer-Height was too Low, if it was at .2
And temp was a little too high for PLA
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion