Hello,

So I just got a Prusa i3. Assembled it over the better part of a day and last night and today I have been on the learning curve to calibration.

I have been printing small cubes as I go and the first one was terrible to say the least. I am now to a point where it does resemble a cube but is not laying out full lines. Even the line it draws around the cube before starting layer one is more dots than a line. Maybe something to do with speed or heat? I am pretty sure my plate is level now.

Look forward to the 3D printing world and all the cool stuff ahead. Thanks for reading.

20151227_131414.jpg