Results 1 to 10 of 25
Threaded View
-
12-13-2015, 11:33 AM #23
- Join Date
- Oct 2015
- Posts
- 11
Post install results
All,
I installed this monitor on my FF Creator Pro and have run it for several days now. Initial thoughts: Works Great!
I had 2 prints pause because of knotted filament. I was able to back up to the utilities menu, unload, straighten the knot, reload, and 'unpause' the printer. There was no noticeable flaw in the print job. I was using Makerware 2.4 at the 'Standard' settings and a 10 second delay on the monitor
For this printer, I would extend the mounting rails so the filament entrance is aligned with the center of the spools which would decrease the potential problems. I had to remove the filament tube holder, https://www.thingiverse.com/thing:409297 that I had installed.
Major note: the slower the print speed the longer the delay needs to be otherwise the monitor pauses the printer frequently. I was testing Ninjaflex filament at 30 mm/sec print speed and had to increase the delay to almost 30 seconds.
Enjoy!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help