Results 1 to 10 of 32
Thread: R.I.P. Power Supply
Threaded View
-
12-12-2015, 02:17 PM #23
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
I think the 270 ohm may be 0.27 ohms so may be hard to get an accurate reading for depending on your meter.
Are you sure you have the multiplier right. It may be 270 across an inductor so should read zero anyway.
As Printbus says, if there is an over current then it will shut down before you even know it has come on.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion