Results 1 to 9 of 9
Thread: Replicator 2 - advice
Threaded View
-
12-10-2015, 02:47 AM #1
- Join Date
- Dec 2015
- Posts
- 4
Replicator 2 - advice
Hello.
The company I work for has a Rep. 2 (Firmware Version 7.4) which has done 1001 hours printing.
The prints have become gradually worse, as expected from a machine which has had almost zero care.
I've been tasked with fixing whats necessary or replacing whats required.
Please see attached images.IMG_6434.jpgIMG_6435.jpg
The most recent two prints are shown in the foreground of the second image (20mm cube and test print)
I have gradually worked the Feedstockmultiplier rate down (from 0.93, in 0.05 increments, finally to 0.73) as described in the document below. This was in an effort to solve the underfeeding and gaps.
http://download.makerbot.com/replica...aintenance.pdf
As you can see it will print a 20mm block OK-ish but ask anything more complicated and the result is poor.
Any help greatly appreciated.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion