Results 1 to 8 of 8
Threaded View
-
12-01-2015, 06:32 PM #1
- Join Date
- Nov 2014
- Posts
- 3
Filament extruding at angle and bunching up around nozzle (video)
I've been trying to figure out what could be causing the filament to becoming out at an angle from the nozzle.
I've cleaned the nozzle at least a dozen time (pushing filament in hot, yanking out, trimming end, repeat) but its still coming out at this angle which is causing it to just stick to the nozzle..
Any tips are appreciated!
Btw this is a Replicator 2X and it's the dissolvable filament
Video:
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion