Results 1 to 10 of 27
Threaded View
-
11-25-2015, 07:04 AM #20
Yes, I can see how the Rough surface of filament could Help it going thru extruder,
more friction at feed-gear should really help, also.
Seems to be Great layer-adhesion at 200C,
I do have it going a little slower when doing outer-walls, with a small size nozzle (.3mm).
Filament hung-up twice on this spool, so far, when it got trapped at outer edge of spool.
I like PETG Much Better than ABS !
I like Any filament Better than ABS ! LOLLast edited by EagleSeven; 11-25-2015 at 07:21 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion