Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
11-13-2015, 07:14 AM #10
The instructions don't really mention it but I removed the screws from the bottom so I could get a better view of the power supply.
The red switch is on the side of the power supply. You will need a screwdriver with a straight blade tip to slide the red switch to 110v.
I think the screws on the bottom where small phillips head.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion