Results 1 to 10 of 10
Threaded View
-
11-05-2015, 03:10 AM #9
Just my 2¢, but the wavy lines issue I've seen on one of my early scans, but usually it was with the turntable, and it happens when you have a shallow viewing angle on start up. If I rotate the model on the turntable and scan again it doesn't do it the same.
Mike
PS. I think the native resolution of the projector is 1024x768, but it's pulled down to 800x600 for the software screens.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion