Results 1 to 2 of 2
Threaded View
-
10-24-2015, 09:20 AM #1
Looking for Fillament recommendation
Good Morning all,
I am working on a part for someone and the prototype I printed out of PLA. He was going to have the parts Machined out of Aluminum, but found out the cost of getting these 6 parts made. He has asked me if I could just print the parts as he needs a set. They are going to adapt a Fuel Injection Manifold to a Carb. Head on a Porsche. The part will bolt directly to the aluminum head with a paper gasket in between. I told him if he bolted that PLA part in, it would turn to Goo. Any recommendations to anything that I could print with that would take the heat?
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion