Results 1 to 6 of 6
Thread: spiking and pit holes
Threaded View
-
10-23-2015, 08:41 AM #1
- Join Date
- Sep 2015
- Location
- South Australia
- Posts
- 89
spiking and pit holes
can anyone help out with these two probs I am having, printing in ABS Temp 220, bed 110, S3D slicer,
I feel so close to a decent print yet so far........................................!
I keep getting spiking issues , especially around the support areas of the print?
there are also small holes in the print, could this be shite filamen, i read some where that moisture plays a part?
you will also note my dismal Kapton application effort! (but I was having these same problems before the kapton was applied) at least the part sticks now!
Cheers
Anthony
1.jpg2.jpg
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion